PENGARUH RADIASI MATAHARI DAN JENIS MATERIAL  COIL PADA PV-MODULE SOLAR ELECTRIC COOKER

Asrori Asrori; Harie S. Jaya

doi:10.37304/jptm.v4i2.5168

Authors

Asrori Asrori Politeknik Negeri Malang
Harie S. Jaya Universitas Palangka Raya

DOI:

https://doi.org/10.37304/jptm.v4i2.5168

Keywords:

PV Module, Solar Electric Cooker, Solar Radiation, Solar Panels, Thermal Conductivity

Abstract

Global energy needs are increasing, while world energy reserves derived from fossils are dwindling. Therefore, a breakthrough is needed to develop green technology based on renewable energy, especially in the household sector. Indonesia is located on the equator so it has great potential to explore solar energy sources. This study aims to analyze the effect of the type of coil heater material and the level of solar radiation on the PV module solar electric cooker. Testing carried out in the Solar Energy Lab., Mechanical Engineering, State Polytechnic of Malang (7°56ʼ36.4ˮS ; 112°36ʼ49.6ˮE). The method used is true experimental using three material types based on their thermal conductivity, namely copper, aluminum, and nickel as well as the change in solar radiation on the heat of solar electric cooker generated by the PV module. The results showed that there was an effect of the parameters of thermal conductivity and changes in solar radiation on the heat generated by the PV module solar electric cooker. In the nickel coil test, it can reach a temperature of 769°C at a solar radiation of 875.9 W/m². Testing the aluminum coil obtained a temperature of 191°C at a solar radiation level of 931.4 W/m², and a copper coil could produce a temperature of 169°C at a solar radiation level of 855.6 W/m²

Downloads

Download data is not yet available.

References

Aminullah, M. W., Haryadi, H., dan Fitria, D. (2022). Perancangan Kompor Listrik Berbasis Panel Surya terhadap Pengaruh Panjang Coil. JTE UNIBA, 6(2), 200-205

Asrori, A., & Yudiyanto, E. (2019). Kajian Karakteristik Temperatur Permukaan Panel terhadap Performansi Instalasi Panel Surya Tipe Mono dan Polikristal. FLYWHEEL: Jurnal Teknik Mesin Untirta, 1(1), 68-73

Asrori, S. S., Wahyudi, S., & Widhiyanuriyawan, D (2014). Konsentrator Lensa Fresnel: Kajian Pemanfaatan Energi Panas Matahari Untuk Aplikasi Kompor Surya. Prosiding SENTIA 2014, Vol: 2085-2347, 17-23

Asrori, A., Suparman, S., Wahyudi, S., & Widhiyanuriyawan, D. (2020). An experimental Study of Solar cooker Performance With thermal Concentrator System by spot Fresnel lens. Eastern-European Journal of Enterprise Technologies, 5 (8-107), 31–41

Astuti, I. A. D. (2015, September). Penentuan Konduktivitas Termal Logam Tembaga, Kuningan, Dan Besi Dengan Metode Gandengan. In PROSIDING: Seminar Nasional Fisika dan Pendidikan Fisika (Vol. 6, No. 1).

Aung, S.S., Wai, H.P, & Soe, N.N. (2008). Design Calculation and Performance Testing of Heating Coil in Induction Surface Hardening Machine, World Academy of Science, Engineering and Technology International Journal of Energy and Power Engineering, 2(6), 1134- 1138.

Batchelor, S., Talukder, M.A.R., Uddin, M.R., Mondal, S.K., Islam, S., Redoy, R.K., Hanlin, R., & Khan, M.R. (2018). Solar e-Cooking: A Proposition for Solar Home System Integrated Clean Cooking. Energies, 11 (11), 2933.

Hasanah, A. W., & Handayani, O. (2016). Perbandingan Efisiensi Energi dan Biaya pada Kompor Induksi terhadap Kompor Listrik Dan Kompor Gas. Jurnal Ilmiah Sutet, 6(2), 22-29.

Tiffany, J.H., & Morawicki, R. (2013). Energy consumption during cooking in the residential sector of developed nations: a review, Food Policy 40 (C), 54-63.

Mulyanto, A. (2011). Perbandingan Konduktivitas tembaga, Baja dan Aluminium. Dinamika Teknik Mesin, 1(1).

Prabu, A.S., Chithambaram, V., Shanmugan, S., Cavaliere, P., Gorjian, S., Aissa, A., Mourad, A., Pardhasaradhi, P., Muthucumaraswamy, R., Essa, F.A.E., & Elsheikh, A.H. (2023). The performance enhancement of solar cooker integrated with photovoltaic module and evacuated tubes using ZnO/Acalypha Indica leaf extract: response surface study analysis. Environ Sci Pollut Res Int. 30(6), 15082-15101.

Paundra, F., & Nurdin, A. (2022). Study Of The Potential And Development Of Renewable Energy Power In Indonesia: A Review. STEAM Engineering (Journal of Science, Technology, Education And Mechanical Engineering), 3 (2), 62– 72.

Siregar, W.P. H., Fawaid, M., Abizar, H., Nurtanto, M., Suhendar, S., & Suyitno, S. (2021). Reflector and passive cooler for optimization of solar panel output. IOP Conf. Ser.: Earth Environ. Sci., 739 (012085).

Sucipto, S., Priangkoso, T., & Darmanto, D. (2013). Analisa Konduktivitas Termal Baja St-37 dan Kuningan. Jurnal Ilmiah MOMENTUM, 9(1).

Yuliananda, S., Sarya, G., & Hastijanti, R. R. (2015). Pengaruh perubahan intensitas matahari terhadap daya keluaran panel surya. JPM17: Jurnal Pengabdian Masyarakat, 1(02).